VIBROSIL, a one-component vibration-insulating silicone sealant, is intended for sealing joints and joints in special sound-insulating structures.The sealant ensures good vibration insulation of the collisions of building structures. Reduces the spread of structural noise in them and thus improves their own sound insulation. Used to fill the joints of sound-insulating floating floors, sound-insulating wall panel systems, sound-insulating frame partitions, linings and suspended ceilings.
Usage:
- usage temperature -10 ° C… +40 ° C
- operating temperature -40 ° C… +150 ° C
- storage temperature 0 ° C… +25 ° C
- guaranteed shelf life 18 months
Features
- firmly seals joints of any thickness
- best vibroacoustic properties
- neutral (does not corrode metals)
- increased humidity and heat resistance
- excellent adhesion to most building materials
Vibroacoustic performance
Dynamic modulus of elasticity Ed, MPa and loss factor on the specimen,kPa | ||||
Vibroacoustic sealant VIBROSIL, four columns 6 mm high | 44,23 | 110,580 | ||
Ed | ƞ | Ed | ƞ | |
0,92ƞ | 0,28 | 1,45 | 0,25 | |
Interaction with materials
Recommended materials for contact with the sealant: concrete, brick, plaster, glass, enamel, metals, ceramics, plastics, lacquered or painted wood.
Safety precautions
Work in well-ventilated rooms. Avoid contact with eyes and skin. In case of contact with skin, rinse immediately with plenty of warm water. The fully cured sealant is odorless and safe to handle.
Installation technology
Clean dustable surfaces of dust, moisture and grease. Apply masking tape along the surfaces of the joint to be sealed. Cut the screw cap of the container above the thread, screw the nozzle into place and cut off the end at a 45-degree angle to achieve the required diameter. Fill the joint with sealant using a silicone gun. Remove sealant residue and form the joint surface. Remove the masking tape and clean the edges of the joint if necessary.
